98.02 feedback

[Anobium]

Sure, procedure is here. See https://sourceforge.net/p/gcbasic/discussion/chipfileforum/thread/bceafec8/#e8a8

Please, please update this post so other can learn from this programmer.

[Gert vd Walt]

thank you. I will give feedback

[stan cartwright]

This popped up while writing a line of code. same line,same bit of code.
Gcb crashed but help stayed open.
Restarted gcb and opened same file,edited same line and same message popped up at same point typing same bit of code.
It was ok 3rd time..I wrote a different line of code. Using win10 pro

[Anobium]

The SynWrite Editor/Lexer does do this once in a while. Not a lot we can do to fix it.

[stan cartwright]

I tried a nano 328p with 98.02.
It's on com port 11. win 7
I set programmer preference to nano/mini 5600 com 11.
When I hex flash says can't connect to com 6... see image.
I tried a nano on another pc with 98.02 win 10 and nano on com port 4.
Said can't connect to com port 5 when hex flash.

[Anobium]

Not enough info.

1. Select Verbose in PPTool.
2. Then program again.
3. You will see which programmer was chosen, and, those rejected.
4. Study that information and it will probably tell you that you do not the one you want for the Nano at the top of the list.

[stan cartwright]

flash hex with verbose ticked. nano is on com port 4.
The type in command line parameters and text appeared with verbose.
default uno and pickit 2/3 must have been ok but not nano.

Loading source files ...
Reading compiler directives ...
Reading chip data ...
C:\GCB@Syn\GreatCowBasic\chipdata\MEGA328P.dat
Choosing programmer ...
Microchip PICKit 2 CLI - Default skipped
Arduino UNO @115200 selected
;
Downloading program ...
Calling C:\GCB@Syn\GreatCowBasic..\avrdude\avrdude.exe
avrdude.exe: ser_open(): can't open device "\.\COM5": The system cannot find the file specified.

avrdude.exe done. Thank you.

A warning has been generated:

Warning: The chip may not have programmed properly. Programmer returned
status (1)

The message has been logged to the file Errors.txt.+++++++++++ where?

Uno is fine. Where do I edit command line parameters please?
I haven't changed anything other than uno to nano and com port which is mouse driven.

[stan cartwright]

Choosing programmer ...
Microchip PICKit 2 CLI - Default skipped
Arduino UNO @115200 selected........................... I chose/edited nano/mini 328 @56000 !

[Chris Roper]

You chose it and edited it but did you actulay set it to the default?
In your image it is still in "other avalable...."
Drag it to the top, that way it becomes the default.

[stan cartwright]

Thanks Chris, that worked. I wouldn't have thought of that.
When I edited uno com port number uno is second, below pickit which is first it says skipped pickit.
I didn't drag uno to the top.
It's still new. Probably says somewhere.