Tutorial_NewSession

To set up a new session, start FREVO with the graphical user interface. The first thing that should be selected is the Problem Implementation. To do this, click on “Select Problem” label, outlined in red. The “Select Problem Component” window will pop up.

• Select a problem component. Here, “Cellular automaton morphogenesis” (Cam) is selected.
• You can adjust parameters in the table. Here, the “simulation steps” parameter is selected. To change a parameter's value, double click and enter a value.
• When you are finished, click “Confirm” at the bottom of the screen.
• Repeat this step to select a Method, Representation and Ranking. In each step you can adjust parameters.

Now you should have defined your parameters. To run the simulation, click the “Play” button and the simulation starts.

One can use the “Reset” button to clear all ongoing simulations.
The bottom half of the screen shows information to the simulation (outlined in red) and the progress bar.
When the simulation is finished, results will be saved in the “FREVO” folder, under “Results”.

[Anita]

Hey Melanie,
Cool du arbeitest ja an Frevo :)
Hoffe dir gehts gut.
Grüße aus Zürich.
Anita

Melanie Schranz melanieschranz@users.sf.net schrieb am Fr., 24. Feb.
2017, 15:02:

--- v8
+++ v9
@@ -3,11 +3,11 @@

• Select a problem component. Here, “Cellular automaton morphogenesis” (Cam) is selected.
  - Define parameters in the table. Here, the “simulation steps” parameter is selected in yellow. To define a parameter, double click and enter a value.
  + You can adjust parameters in the table. Here, the “simulation steps” parameter is selected. To change a parameter's value, double click and enter a value.
• When you are finished, click “Confirm” at the bottom of the screen.
  - Repeat this step for the Method, Candidate Representation and Ranking, selecting the required parameters.
  + Repeat this step to select a Method, Representation and Ranking. In each step you can adjust parameters.

-
+

Now you should have defined your parameters. To run the simulation, click the “Play” button and the simulation shall start.

---

Sent from sourceforge.net because you indicated interest in
https://sourceforge.net/p/frevo/wiki/Tutorial_NewSession/

To unsubscribe from further messages, please visit
https://sourceforge.net/auth/subscriptions/

[Melanie Schranz]

Hallo Anita!!
Ja so schließen sich die Kreise :)

Wie geht es dir? Es wäre toll, wenn wir uns mal wieder treffen könnten, wann bist du vl. wieder mal in Kärnten?

LG, Melanie