Hi there,
I am facing weird problem with my Application on PSoC 5 based hardware. This application is based on FreeRTOS, and application contains 128×64 kind of monochromatic LCD (Graphical LCD), having controller like ks0107.
We are attaching:
The problem is that if we run this program with the PIN used for CY8CKIT-050, it runs smoothly and complete every task as desired with no problem at all. But if we only change the MCU PINs as used in our Hardware and program the Hardware MCU with same program, application runs to certain point and than hang. We tried debug mode and found out that after running for some time application goes to :
CY_ISR(IntDefaultHandler)
{
while(1)
{
/***********************************************************************
* We must not get here. If we do, a serious problem occurs, so go
* into an infinite loop.
***********************************************************************/
}
}
which is in Cm3Start.c. And at this point application stays in hanged state.
Here please note that this only happens if we used the same program in our Hardware. But if we use it in Kit (CY8CKIT-050), it runs completely fine without any fault.
We would like to also share that we have used FreeRTOS prior to this application, and we have successfully built applications with FreeRTOS.
Will you please check this files and see if we have made any mistake anywhere?
This appears to be a support request, not a bug report. Please use the support forum provided. A link to the support forum can be found at the top of every page on the main http://www.freertos.org web page, near the logo.