Re: [Flashforth-devel] Help

[Mikael N. <mik...@fl...>]

Probably the flash or eeprom is corrupted.

Maybe you did not erase the eeprom when you programmed the chip.

Reprogram the FF to the chip, with your programmer set  to erase flash 
and eeprom.

BR Mikael

On 2019-02-23 17:02, craig bair via Flashforth-devel wrote:
> Welcome in, Martin.
> If it gets that far, the system is usually good.  I'm used to seeing
> that on power-up, but a prompt comes back for me after hitting <ret>.
> I run the PIC18 and Arduino versions of FlashForth 5.0, what are you 
> using?
> craig bair
> 
> --------------------------------------------
> On Tue, 2/19/19, Martin Mainka <ma...@ma...> wrote:
> 
>  Subject: [Flashforth-devel] Help
>  To: fla...@li...
>  Date: Tuesday, February 19, 2019, 4:49 AM
> 
>  Hi, i am new to flashforth
> 
>  What to do if the system is only
>  responding ESC after the Flashforth
>  text, but no prompt? I did reset and
>  disconnect from power. No commands
>  are accepted.
> 
>  many thanks in advance
> 
>  Martin
> 
> 
> 
>  _______________________________________________
>  Flashforth-devel mailing list
>  Fla...@li...
>  https://lists.sourceforge.net/lists/listinfo/flashforth-devel
> 
> 
> 
> _______________________________________________
> Flashforth-devel mailing list
> Fla...@li...
> https://lists.sourceforge.net/lists/listinfo/flashforth-devel

-- 
--
Mikael