Re: [Flashforth-devel] FIXED was disPIC33E... build list in flash?

[Joe E. <je...@bo...>]

Yep, should have known I couldn't move straight across from 18f to 33e.

I'm having gobs of fun w/ 5.0 on 33e!

Thanks Mike.

--
joe

On Thu, 19 Jan 2017 07:30:08 +0200 Mikael Nordman
<mik...@fl...> wrote:

> You need to ALIGN the flash dictionary pointer after you've created
> the list in flash.
> 
> HERE would have shown you an uneven address after the last C,
> 
> The 16-bit PIC throws an hardware address exception for an
> unaligned word write to the flash buffer in ram.
> 
> Mike
> 
> 
> On 2017-01-19 02:21, Joe Ennis wrote:
> > Came up against one that has me puzzled:
> > 
> > Say I create a char list in flash with
> > 
> > 	hex flash create foo 1b c, f2 c, 57 c, ram
> > 
> > then if I try to define some word
> > 
> > 	: bar .s ;
> > 
> > I get "warm" with an address and software reset error.
> > 
> > All this works fine if I substitute ram for flash above.
> > Is it not possible to create a list in flash?
> > 
> > Or is there a better way to create a read only list that
> > is available across power cycles?
> > 
> > --
> > joe
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, SlashDot.org! http://sdm.link/slashdot
> _______________________________________________
> Flashforth-devel mailing list
> Fla...@li...
> https://lists.sourceforge.net/lists/listinfo/flashforth-devel