Re: [Flashforth-devel] Gtkterm - Upload to FF - works great

[Mikael N. <mik...@fl...>]

With 38.4 Kbaud gtkterm to a 7.5 Mhz Fcy dspic it takes 14.5 seconds to 
send float.txt using gtkterm.

Still, on Linux I prefer to use the ff-shell.py.
It adds command line editing and history, and the #send command works
from the command line.

BR Mike

On 21.05.2015 02:04, om1zz wrote:
> Hi, I've tried the Gtkterm under Ubuntu.
> It works so great!
> It uploads float.txt in 9(!!) seconds at 115k2, inclusive all comments and blank lines, with zero line transmit delay, with following setup:
>
> 1. dspic33 = 16.6MHz Fcy, baud 115k2, CA-42 usb dongle, rx buffer=127, tx buffer=15
> 2. Gtkterm:
> Configuraton>Port: 115k2 8N1, xon/xoff (not used actually, it seems there is a bug as this switches xon/xoff actually off)
> Port: Advanced options: In Wait for this special character..: set CRLF (that is tricky - I've found a copy/paste of CRLF from an editor does the trick, you will see a small picture in a rectangle (single char) in the input field there then).
>
> Also mind to get the Configuration options you have to do sudo gtkterm, then save the configuration as the opening configuration again means you loose the previously entered info ;)
>
> Unbelievable fast!!
> Igor.
>
> ------------------------------------------------------------------------------
> One dashboard for servers and applications across Physical-Virtual-Cloud
> Widest out-of-the-box monitoring support with 50+ applications
> Performance metrics, stats and reports that give you Actionable Insights
> Deep dive visibility with transaction tracing using APM Insight.
> http://ad.doubleclick.net/ddm/clk/290420510;117567292;y
> _______________________________________________
> Flashforth-devel mailing list
> Fla...@li...
> https://lists.sourceforge.net/lists/listinfo/flashforth-devel
>