Re: [Flashforth-devel] ff on the microstick 2 / microstick plus development board

[<mik...@fl...>]

I leave PIN 11 (RTS !) disconnected.
/Mike

On 26.01.2015 19:56, Mark Goldman wrote:
> When you soldered pin 13 (CTS) on the MCP2200 to RB12, did you leave
> pin 10 (RTS) connected?
>
> -mdg
>
> On Sun, Jan 11, 2015 at 3:12 AM,
> <fla...@li...> wrote:
>> You need to configure the UART pins in config file p33_config.inc.
>> .equ RPINR18VAL, 11     ; U1RXPIN RP43 PB11 pin22 microstick2
>> .equ U1TXPIN, 10        ; PB10 pin21 microstick2
>>
>> If you use HW flow control you need the separate the CTS RTS pins on 
>> the
>> MCP2200
>> and connect RB12 to the CTS pin13 on the MCP2200.
>> And define the RTS pin in the FF config file.
>> .equ U1RTSPIN, 12       ; Solder to MCP2200 CTS pin13 on 
>> microstickplus if
>> HW flow control