Re: [Flashforth-devel] ff on the microstick 2 / microstick plus development board

[Mark G. <bit...@gm...>]

When you soldered pin 13 (CTS) on the MCP2200 to RB12, did you leave
pin 10 (RTS) connected?

-mdg

On Sun, Jan 11, 2015 at 3:12 AM,
<fla...@li...> wrote:
> You need to configure the UART pins in config file p33_config.inc.
> .equ RPINR18VAL, 11     ; U1RXPIN RP43 PB11 pin22 microstick2
> .equ U1TXPIN, 10        ; PB10 pin21 microstick2
>
> If you use HW flow control you need the separate the CTS RTS pins on the
> MCP2200
> and connect RB12 to the CTS pin13 on the MCP2200.
> And define the RTS pin in the FF config file.
> .equ U1RTSPIN, 12       ; Solder to MCP2200 CTS pin13 on microstickplus if
> HW flow control
>
> Attached is the config file I just tried with my dsPIC33FJ128MC802.
>
> BR Mike
>
> ------------------------------------------------------------------------------
> Dive into the World of Parallel Programming! The Go Parallel Website,
> sponsored by Intel and developed in partnership with Slashdot Media, is your
> hub for all things parallel software development, from weekly thought
> leadership blogs to news, videos, case studies, tutorials and more. Take a
> look and join the conversation now. http://goparallel.sourceforge.net
> _______________________________________________
> Flashforth-devel mailing list
> Fla...@li...
> https://lists.sourceforge.net/lists/listinfo/flashforth-devel
>



-- 
Our problems are mostly behind us, now all we have to do is fight the solutions.