Re: [Flashforth-devel] FF5.0 on Arduino Uno R3

[Rob <rsc...@op...>]

Hi,

The fuses are set as:

Lfuse: 0xFF
  Hfuse: 0xDE   BOOTSZ0=1 BOOTSZ1=1 BOOTRST=0
Efuse: 0x05
Lock Bits: 0x3f

I used Teraterm with XON/XOFF and without. Both display "EBM lashForth 
Atmega 5.0" when the Uno is reset.

Flash contents read back match the original hex file.

Thanks for your response.

Rob Scholten.




On 01-Aug-14 4:38 PM, Mikael Nordman wrote:
> Hi Rob.
>
> Please reply to the list and no to me personally.
>
> How did you set the fuses on the chip ?
>
> Do you have XON/XOFF enabled in your terminal program ?
>
> BR Mike
>
> On 31.07.2014 15:10, Rob wrote:
>> Hi,
>> I programmed the Uno R3 via a UsbTiny program. No verification errors,
>> but a connected terminal returns
>> "EBM lashForth Atmega 5.0" . The Arduino does not respond to any key
>> input. The hex file is correct in that this line reads "ver 3.2
>> FlashForth Atmega 5.0".
>> I've tried two ATMega 328P chips.
>> Is anyone else getting this problem?
>> Thanks.
>>
> ------------------------------------------------------------------------------
> Want fast and easy access to all the code in your enterprise? Index and
> search up to 200,000 lines of code with a free copy of Black Duck
> Code Sight - the same software that powers the world's largest code
> search on Ohloh, the Black Duck Open Hub! Try it now.
> http://p.sf.net/sfu/bds
> _______________________________________________
> Flashforth-devel mailing list
> Fla...@li...
> https://lists.sourceforge.net/lists/listinfo/flashforth-devel
>