Hopefully this is now a bugfree FlashForth for the PIC18F.
Mikael
FlashForth V3.6
- Corrected CRLF handling in ACCEPT
CRLF, CR and LF are accepted as end of line.
- Binary communication option in TX1 and RX1
- FL0 FL1 Memory write protection
- FT0 FT1 Disable flow control on TX1/RX1
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have FlashForth v3.6 up and running on a PIC18F6527. Looks very good so far. Many new things to check out, like H/W flow control. I am still using older terminal programs like Procomm Plus and NMIterm from New Micros to connect to the PIC and have had no problems. I typically run the PIC at 32MHz and the baud rate at 38.4k .
I have revisited apps such as the Walsh Transform and LCD Driver here to make sure word names do not exceed 15 characters and all is running fine.
Folks should like this release of FF for PIC18 devices.
Thanks for the FF update Mikael.
Pete
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hopefully this is now a bugfree FlashForth for the PIC18F.
Mikael
FlashForth V3.6
- Corrected CRLF handling in ACCEPT
CRLF, CR and LF are accepted as end of line.
- Binary communication option in TX1 and RX1
- FL0 FL1 Memory write protection
- FT0 FT1 Disable flow control on TX1/RX1
I have FlashForth v3.6 up and running on a PIC18F6527. Looks very good so far. Many new things to check out, like H/W flow control. I am still using older terminal programs like Procomm Plus and NMIterm from New Micros to connect to the PIC and have had no problems. I typically run the PIC at 32MHz and the baud rate at 38.4k .
I have revisited apps such as the Walsh Transform and LCD Driver here to make sure word names do not exceed 15 characters and all is running fine.
Folks should like this release of FF for PIC18 devices.
Thanks for the FF update Mikael.
Pete
Fed-Ex just dropped off PicKit-2 clone and UB232R.. Up and running 3.6..
Sweet!