Re: [Evms-devel] EVMS RAID 5 error...add 0 spares?

[<tho...@ao...>]

 Hello,
 
 Here is the output you requested:
 
 
 -bash-3.00# cat /proc/mdstat
 Personalities : [raid0] [raid1] [raid5] [raid10]
 md0 : active raid5 dm-7[2] dm-6[1] dm-5[0]
 878882304 blocks level 5, 512k chunk, algorithm 0 [4/3] [UUU_]
 
 unused devices: <none>
 -bash-3.00#
    
 -----Original Message-----
 From: sk...@gm...
 To: tho...@ao...
 Cc: evm...@li...
 Sent: Mon, 14 May 2007 7:54 AM
 Subject: Re: [Evms-devel] EVMS RAID 5 error...add 0 spares?
 
  On 5/13/07, tho...@ao... <tho...@ao...> wrote: 
 > 
 > 
 > Hi all, 
 > 
 > I created a RAID 5 set using EVMS 2.5.5 on Linux 2.6.12, and it seemed to be proceeding along just fine...going thru the initial synchronization. Now I checked in on the RAID set and found this message when launching EVMS 
 > 
 > 
 > -bash-3.00# /usr/evms/sbin/evms 
 > 
 > EVMS Command Line Interpreter Version 2.5.5 
 > 
 > MDRaid5RegMgr: Region md/md0 is currently in degraded mode. To bring it back to 
 > normal state, add 0 new spare device to replace the faulty or missing device. 
 > 
 > MDRaid5RegMgr: Region md/md0 : MD superblocks found in object(s) [sdj1 ] are not 
 > valid. [sdj1 ] will not be activated and should be removed from the region. 
 > 
 > Engine: Error code 5 (Input/output error) when reading the primary copy of 
 > feature header on object dm-0. 
 > 
 > Engine: Error code 5 (Input/output error) when reading the secondary copy of 
 > feature header on object dm-0. 
 
 Could you run the following command and reply with the output: 
 
 # cat /proc/mdstat 
 
 > 
 > 
 > I'm confused about this message and what the actual problem is...add 0 new spare device?? Any guidance would be appreciated! 
 > 
 > Thanks 
 
 
 -- Scott Kaelin 
 Sitrof Technologies 
 sk...@si... 
   
________________________________________________________________________
AOL now offers free email to everyone.  Find out more about what's free from AOL at AOL.com.