Re: [Emc-users] Moving axis while paused

[Drew R. <dr...@Da...>]

Andy,

They're in the "Tabs" item in the Geometry tab of the 2D Contour CAM operation. They may also be in other CAM operations but I haven't run into them yet.

Drew

On 6/27/16 8:56 AM, andy pugh wrote:
> On 27 June 2016 at 15:28, Chris Kelley <ten...@gm...> wrote:
>> I would say that the "proper answer" is to teach the users to properly use
>> holding-tabs, hold-downs, etc
> That reminds me, I used holding tabs a lot in CamBam, but haven't even
> found them in Fusion360 or Inventor HSM. I wonder if they are there to
> be found?
>
> However, to say that it is possible to never need to stop a job
> part-way through to fix something is, I think, going a bit far. As I
> recall the moveoff component was written after a request from a
> commercial roll-machining company who wanted to be able to change
> chipped or worn tips mid-job.
>

-- 
Drew Rogge
dr...@da...

Phone: 8934OOO629OO4829631OOOOOOO