Re: [Emc-users] Moving axis while paused

[andy p. <bod...@gm...>]

On 27 June 2016 at 15:28, Chris Kelley <ten...@gm...> wrote:
> I would say that the "proper answer" is to teach the users to properly use
> holding-tabs, hold-downs, etc

That reminds me, I used holding tabs a lot in CamBam, but haven't even
found them in Fusion360 or Inventor HSM. I wonder if they are there to
be found?

However, to say that it is possible to never need to stop a job
part-way through to fix something is, I think, going a bit far. As I
recall the moveoff component was written after a request from a
commercial roll-machining company who wanted to be able to change
chipped or worn tips mid-job.

-- 
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916