From: Todd Z. <zue...@em...> - 2016-02-13 13:03:21
|
This might be a better question for the developers list. Also post a feature request. But it would probably be simpler to temporarily remap your W-axis joint to the Z for the bit of code where you tap then switch back. I've also ran into a similar problem using the new tool planner doing 3-d engraving with W-axis code. The problem is also present in the old tool planner, but it isn't as noticeable, because of the slower speeds. I worked around it in a similar fashion. I was able to convince the author of the new planner to work on a build that worked for me, it was baised on 2.7.2. I don't use tapping so I have no idea if it would help at all (doubt it). I also don't know if those fixes are planned to be merged into the regular code. ----- Original Message ----- From: "robert - Innovative-RC" <ro...@in...> To: "Enhanced Machine Controller (EMC)" <emc...@li...> Sent: Saturday, February 13, 2016 4:50:15 AM Subject: [Emc-users] Rigid Tapping in U,V,W hi what would it take to add or finish adding U V W rigid tapping ? as i see when you command G33.1 with a W it is accepted but goes to postion and just does the next line of code with out doing the tapping move. so it looks like someone might have started adding rigid tapping in U V W? i use all drill cycles etc in the W axis but id love to use rigid tapping in W also. i am no coder but id take alook at finishing the job if someone pointed us in the right directions, is it just a case of finishing off the interp cycles ?? or if there someone much more cleaver than me who would take on finishing it off? thanks, Rob -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140 _______________________________________________ Emc-users mailing list Emc...@li... https://lists.sourceforge.net/lists/listinfo/emc-users |