From: Gene H. <ghe...@wd...> - 2013-12-30 11:09:34
|
On Monday 30 December 2013 06:01:46 Marius Liebenberg did opine: > I am trying to setup some subroutines to do tool length and touchoff > calculations. Where can I see the #parameters while the system is > running. I am storing a value in say #1000 and then I want to use it > later in another sub. I am not sure if my data is correct as I keep on > ending up above the job for some reason. I've done something similar, but used #100 & up, for probing locations and tool lengths for pcb etching. Seems to work well for me. I might revisit it and use named vars at some point. I didn't expect them to live past a gcode reload of a different file that uses the same variable name but they do. Some folks might consider that to be a security issue, but its been handy several times. Cheers, Gene -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> It's bad enough that life is a rat-race, but why do the rats always have to win? A pen in the hand of this president is far more dangerous than 200 million guns in the hands of law-abiding citizens. |