Re: [Emc-users] tool table

[andy p. <bod...@gm...>]

On 29 July 2012 12:55, jeremy youngs <jcy...@gm...> wrote:
> heres the tool table. I tried g10 l1 and it had the same error, i wrote
> tool 5 in and saved the file . I dont understand why it sees all the other
> tools?

I tried your tool.tbl in a sim, and get the same result.

By removing the two trailing newlines from the file, saving then
reloading from the Axis "file" menu I was able to get LinuxCNC to see
the tool.
Similarly, opening the tool-table editor, checking the file, writing
the file, then reloading in Axis also works.

I am not sure what the actual problem is, it seems like the
file-parser might be less robust than one might hope.

-- 
atp
If you can't fix it, you don't own it.
http://www.ifixit.com/Manifesto