Re: [Emc-users] Status of iocontrol version 2

[Karl C. <ka...@ke...>]

Thanks. I see it now.  Is iocontrol-v2 planned for inclusion in 2.5?

Karl


On 08/31/2011 08:21 AM, Michael Haberler wrote:
> You might checkout the iocontrol-v2 related files from master
>
> -Michael
>
> Am 31.08.2011 um 16:51 schrieb Karl Cunningham:
>
>> All,
>>
>> I am working on a tool changer realtime component, and have run into
>> problems with lack of fault handling that are described on the following
>> page:
>>
>> http://wiki.linuxcnc.org/emcinfo.pl?ToolchangerProtocolProposal
>>
>> The above document says there is a demo config for iov2:
>> axis-iocontrolv2-demo.ini.
>>
>> I installed emc2 2.5 simulation and don't see the above ini file, or any
>> mention of iov2. What am I missing?
>>
>> Thanks.
>>
>> Karl