From: Spiderdab <77...@ti...> - 2010-11-28 21:27:22
|
Il 28/11/2010 19:14, Kirk Wallace ha scritto: > On Fri, 2010-11-26 at 19:31 +0100, Spiderdab wrote: > >> Hallo gentelmen developers, which i'm not..unfortunately. >> i would like to take your attention on this thread : >> http://www.linuxcnc.org/component/option,com_kunena/Itemid,20/func,view/id,5592/catid,20/limit,6/limitstart,0/lang,english/ >> that i started for asking about a new feature needed into emc2. so i >> would like to know if you think there's a possibility of adding a more >> flexible and 'live' control of acceleration ramps (i wish through g-code..). >> the point is the need of doing some movement with a fast acc/dec ramp, >> other with a slow one, into the same g-code program. >> > Can't a CAM create g-code with the proper accelerations as very short > G1's? > no, i tryed this way, but it's a real pain. also because i draw a path in 3dsmax, than through a script create a g-code which i have to change manually to adapt, since the script is meant for milling.. after that we try one time the 'show' and then someone ask me if a certain movement can be more accelerated or less, faster or slower, 5cm more on the left.... it's a pain to go back to 3dstudio, change the density of points in that point, then play the script again, than modify again by hand... can you imagine doing this a hundred times in a day?!? > BTW: I saw Cirque du Soleil's KA on PBS yesterday. The wire fliers > reminded me of the floating ball setup. > :) that's my job! there's an idea on next summer to make a robotic bird fly accross a roman theater! that will be a great try! ciao! |