Re: [Emc-users] Tool length settings

[Steve B. <st...@pi...>]

On Fri, 8 Oct 2010 21:32:41 -0500, you wrote:

>  This discussion has been about measuring the tool's length and writing it
>into the tlo offset register (file). The method I was desiring (and now
>have) is to use a standard height set gage on the machine table top, move
>the tool axis down to the gage height, use the 'set tool' option in touchy
>to G10 L11 P(tool offset number) Z0 and have the control calculate the tool
>length to an arbitrary number that matches the tool length measured on an
>offline tool length measuring machine.

Is this a change to the default behaviour or an alternative "set able"
somewhere in an ini file?

Steve Blackmore
--