From: Jon E. <el...@pi...> - 2010-08-31 05:03:03
|
Igor Chudov wrote: > Jon, is this ebay encoder compatible with your PPMC? > All HEDS encoders should be compatible. Possibly you'd need pull-up resistors, but I don't think you even need that. These are not differential, so if you were going to feed them into an encoder counter, you'd need to set that channel to single-ended mode with the jumpers. > And is Digikey item GH6101-ND compatible with PPMC? > Yes, same thing about single-ended, and the data sheet clearly shows pull-up resistors will be needed. probably 1K Ohm would work fine. I guess you get 64 quadrature counts per rev on this one. Jon |