Re: [Emc-users] Spindle Noses

[Steve S. <ste...@ne...>]

These bolt holes are used for mounting large face
mills. They use a centering plug in the taper but
do not rely on a drawbar to hold them into the
spindle. The plug is not a permanent part of the
face mill, but rather an accessory used with an
other face mills.  

> -----Original Message-----
> From: Andy Pugh [mailto:an...@an...] 
> Sent: Wednesday, June 30, 2010 10:03 AM
> To: Enhanced Machine Controller (EMC)
> Subject: [Emc-users] Spindle Noses
> 
> My milling machine has 4 M10 holes on the face of the 
> spindle. (It is a 30 INT). it appears that these are part of 
> the specification for 30INT. Has does anyone know what they are for?
> 
> http://i200.photobucket.com/albums/aa294/oldtiffie/machine_tap
> ers/Machine-taper5.jpg
> 
> --
> atp
> 
> --------------------------------------------------------------
> ----------------
> This SF.net email is sponsored by Sprint What will you do 
> first with EVO, the first 4G phone?
> Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
> _______________________________________________
> Emc-users mailing list
> Emc...@li...
> https://lists.sourceforge.net/lists/listinfo/emc-users
>