Re: [Emc-users] Attempt to design servo based DIY CNC for Sherline fromOOB components

[Chris R. <ch...@ti...>]

On Fri, Aug 01, 2008 at 12:45:46PM -0700, noel wrote:
> 
> For an inexpensive servo drive: 
>   http://www.xavien.com/   look at the 'Robotics' page.
> I have several of their XDDCMD-1 drives.  They work fine with the Mesanet
> m5i20 board.

Speaking of mesa, you could do this quite well with the 7i30 which
is a quad 100 watt motor driver.  You would also avoid any problem 
that might be caused by software encounter reading's limited speed.