Menu ▾ ▴

#380 Stepconf wizard. Timing driver settings

2.6
closed-fixed
nobody
None
1
2014-08-05
2014-07-26
Eric Agis-Garcin
No

Environment:
Wheezy(7.6)-iso
linuxcnc2.6.0~pre5 (new RTAI) from:
www.linuxcnc.org/binary.hybrid.iso

In Stepconf, if Driver type -> other

It's not possible to set:
Step Time, Step Space and Direction Hold beyond 100ns
Direction Setup beyond 100000ns

Discussion

  • Gleap Site

    Gleap Site - 2014-08-03

    I've reproduced this behaviour on a Fresh install on Ubuntu 12.4 (precise) following the instructions here:
    http://wiki.linuxcnc.org/cgi-bin/wiki.pl?UpdatingTo2.6

     

  • Sebastian Kuzminsky

    Sebastian Kuzminsky - 2014-08-04

    This bug is a duplicate of #385, which has a bit more information in it.

    Chris Morley believes he fixed it in v2.6.0-3-g1f5f8d8 (available from git and from the buildbot). Could you test it and let us know if you get the correct behavior?

     

  • Sebastian Kuzminsky

    Sebastian Kuzminsky - 2014-08-05
    • status: open --> closed-fixed
     

  • Sebastian Kuzminsky

    Sebastian Kuzminsky - 2014-08-05

    fixed in commits 1f5f8d89 and ebc07853, will be part of 2.6.1.