Hello!
I wanted to know if optimal placement and sizing of storage can be done in OpenDSS. I am in the starting phase of my research and also I am a beginner in OpenDSS. Either we can use OpenDSS COM interface with MATLAB or we can perform Real time analysis in softwares like RTDS by using the results of OpenDSS.
I have a 315 node system with PV penetration and a problem of overvoltage during low loading. For this I want to integrate storage in my system. I am in confusion whether starting with OpenDSS will help or not.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I would think that it would be a whole lot easier to do the analysis on OpenDSS than to set the problem up on RTDS. Formulate your optimization algorithm in MATLAB, or whatever, and utilize OpenDSS through the COM interface to see how the distribution system will behave.
I'm curious: Why do you need real time to optimize placement and sizing of storage?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Thank you so much, sir, for the reply. I will use RTDS to validate the
results of the storage capacity determined using the steady-state analysis
of the system. Is there any example given for optimal sizing of battery in
OpenDSS?
I would think that it would be a whole lot easier to do the analysis on
OpenDSS than to set the problem up on RTDS. Formulate your optimization
algorithm in MATLAB, or whatever, and utilize OpenDSS through the COM
interface to see how the distribution system will behave.
I'm curious: Why do you need real time to optimize placement and sizing of
storage?
Hello!
I wanted to know if optimal placement and sizing of storage can be done in OpenDSS. I am in the starting phase of my research and also I am a beginner in OpenDSS. Either we can use OpenDSS COM interface with MATLAB or we can perform Real time analysis in softwares like RTDS by using the results of OpenDSS.
I have a 315 node system with PV penetration and a problem of overvoltage during low loading. For this I want to integrate storage in my system. I am in confusion whether starting with OpenDSS will help or not.
I would think that it would be a whole lot easier to do the analysis on OpenDSS than to set the problem up on RTDS. Formulate your optimization algorithm in MATLAB, or whatever, and utilize OpenDSS through the COM interface to see how the distribution system will behave.
I'm curious: Why do you need real time to optimize placement and sizing of storage?
Thank you so much, sir, for the reply. I will use RTDS to validate the
results of the storage capacity determined using the steady-state analysis
of the system. Is there any example given for optimal sizing of battery in
OpenDSS?
On Fri, Jun 14, 2019 at 12:41 AM Roger Dugan rdugan@users.sourceforge.net
wrote:
--
Regards
Tripti Gangwar
Research Scholar
IIT Roorkee