As suggested in the forum for one element output. I used commands below in interface:
select pvsystem.XYZ;
powers;
However, I do not know how to see results of this. You have mentioned to do conversion in interface. I am not sure what kind of command I can use for this. Would you please guide in this matter.
I also want to see the results of these two commands in standalone, is this possible?
I put together a simple example for you to try out (attached). If you run it using the standalone executable, just make sure to check the Results tab as shown in the screenshot. You’ll see the outputs listed as P and Q for each phase (P1, Q1, P2, Q2, P3, Q3).
Hi OpenDSS Team,
As suggested in the forum for one element output. I used commands below in interface:
select pvsystem.XYZ;
powers;
However, I do not know how to see results of this. You have mentioned to do conversion in interface. I am not sure what kind of command I can use for this. Would you please guide in this matter.
I also want to see the results of these two commands in standalone, is this possible?
I also have looked into these two links:
https://sourceforge.net/p/electricdss/discussion/beginners/thread/c1ae7d30ea/?limit=25#e2fd/59dc
https://sourceforge.net/p/electricdss/discussion/861977/thread/c316f7f3/?limit=25#e601
Hi Sam,
I put together a simple example for you to try out (attached). If you run it using the standalone executable, just make sure to check the Results tab as shown in the screenshot. You’ll see the outputs listed as P and Q for each phase (P1, Q1, P2, Q2, P3, Q3).
Best,