I am using HW+/DXR3 0.13.0 driver. The driver was successfully complied and the modules was perfect loaded. But after I loaded the microcode into the em8300 and run em8300setup, the TV got green screen. I have tried all listed settings in README-modoptions, but they did not help, the scree still green. I also tried extract_mpeg2 test.mpg > /dev/em8300_mv-0, the green screen flashed and then still in green. Do you have any ideas and suggestions?
Thanks in advance.
Sam
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have the same problem with ubuntu breezy kernel 2.6.12. Modules were compiled and loaded. I got the screen to show black by changing pixelport_16bit=0 option.
I didn't work no matter what I do.
Thanks for help
Janne
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am using HW+/DXR3 0.13.0 driver. The driver was successfully complied and the modules was perfect loaded. But after I loaded the microcode into the em8300 and run em8300setup, the TV got green screen. I have tried all listed settings in README-modoptions, but they did not help, the scree still green. I also tried extract_mpeg2 test.mpg > /dev/em8300_mv-0, the green screen flashed and then still in green. Do you have any ideas and suggestions?
Thanks in advance.
Sam
I have the same problem with ubuntu breezy kernel 2.6.12. Modules were compiled and loaded. I got the screen to show black by changing pixelport_16bit=0 option.
I didn't work no matter what I do.
Thanks for help
Janne