From: <ch...@ya...> - 2004-06-30 21:01:06
|
El mi=E9, 30-06-2004 a las 22:09, Roland Scheidegger escribi=F3: > ch...@ya... wrote: > > Hi!, > > > > I have a Debian SID runing on hp-compaq nx9010 laptop with ATI Radeon > > Mobility IGP345M After a lots of tries to compile dri+drm+mesa I got > > the errors attached in this mail. > Hmm, no idea there. There were some very recent commits in that area > I've not yet synced up to. > > > So, I've decide to install the common-20040629-linux.i386.tar.bz2 and > > r200-20040629-linux.i386.tar.bz2 binary snapshots from > > http://www.freedesktop.org/~dri/snapshots/ > > > > After installation, I recompiled and install the radeon kernel module > > with success, then I reload the module, reconfigure XF86Config-4 and > > the thing seemt to work: Here's some kernel output: > > > > Linux agpgart interface v0.100 (c) Dave Jones agpgart: Detected Ati > > IGP345M chipset agpgart: Maximum main memory to use for agp memory: > > 149M agpgart: AGP aperture is 64M @ 0xd4000000 > > > > [drm] Initialized radeon 1.11.0 20020828 on minor 0: ATI Technologies > > Inc Radeon IGP 340M <<< I have 345M, there's no difference? [drm] > Probably not in the graphics core (though could be clocked differently). > > > Used old pci detect: framebuffer loaded agpgart: Found an AGP 2.0 > > compliant device at 0000:00:00.0. agpgart: Putting AGP V2 device at > > 0000:00:00.0 into 4x mode agpgart: Putting AGP V2 device at > > 0000:01:05.0 into 4x mode > > > > However, after enter the X and run some 3d apps to test the 3d > > acceleration (Blender, Tuxracer, glxgears), the systems hangs > > (Blender in concrete, stills with his grey background however I can > > move the mouse). Then I run glxinfo to assure that DRI is working and > > got this message: > > > > name of display: :0.0 unknown chip id, assuming full radeon support > > display: :0 screen: 0 direct rendering: Yes .....and lots of > > output.... > That's not good (your chip will certainly crash when the driver assumes > full support, as it doesn't have a TCL unit). What's the pci id of the > chip (lspci -v)? > > Roland > could be 01:05.0? Here's the output: VGA compatible controller: ATI Technologies Inc: Unknown device 4337 (prog-if 00 [VGA]) Subsystem: Hewlett-Packard Company: Unknown device 0850 Flags: bus master, stepping, fast Back2Back, 66Mhz, medium devsel, latency 66, IRQ 10 Memory at d8000000 (32-bit, prefetchable) [size=3D128M] I/O ports at 9000 [size=3D256] Memory at d0300000 (32-bit, non-prefetchable) [size=3D64K] Expansion ROM at <unassigned> [disabled] [size=3D128K] Capabilities: [58] AGP version 2.0 Capabilities: [50] Power Management version 2 However, I got 2 entrys more, host bridge and pci bridge: 00:00.0 Host bridge: ATI Technologies Inc: Unknown device cbb2 (rev 02) Flags: bus master, 66Mhz, medium devsel, latency 64 Memory at d4000000 (32-bit, prefetchable) [size=3D64M] Memory at d0009000 (32-bit, prefetchable) [size=3D4K] Capabilities: [a0] AGP version 2.0 00:01.0 PCI bridge: ATI Technologies Inc: Unknown device 7010 (prog-if 00 [Normal decode]) Flags: bus master, 66Mhz, medium devsel, latency 99 Bus: primary=3D00, secondary=3D01, subordinate=3D01, sec-latency=3D68 I/O behind bridge: 00009000-00009fff Memory behind bridge: d0300000-d03fffff Prefetchable memory behind bridge: d8000000-dfffffff I got this info too entering cat /proc/pci (that's the same..I think..): Bus 1, device 5, function 0: VGA compatible controller: ATI Technologies Inc Radeon IGP 340M (rev 0). IRQ 10. Master Capable. Latency=3D66. Min Gnt=3D8. Prefetchable 32 bit memory at 0xd8000000 [0xdfffffff]. I/O at 0x9000 [0x90ff]. Non-prefetchable 32 bit memory at 0xd0300000 [0xd030ffff]. Thanks, Chronoh |