Re: [Dev-C++] FREE download: a HOW-TO use wxWindows with Dev-C++

[Yeoh H. <ye...@ye...>]

----- Original Message -----
From: "Brian Ackermann" <bri...@gm...>
To: <dev...@li...>
Sent: Friday, June 20, 2003 10:14 PM
Subject: Re: [Dev-C++] FREE download: a HOW-TO use wxWindows with Dev-C++


> Yeoh, and others
>
> I've done according to the instructions in this document, and,
> unfortunately I get the same problem I had gotten before.  The
> application compiles (but Dev-Cpp cannot run it, I must go through the
> explorer for that...) but when it executes, immediately it generates an
> error
>
> The exception unknown software exception (0xc00000fd) occurred in the
> application at location 0x0040d40d.
>
> However, the application will compile if I do a  "make -f makefile.unx"
> the application compiles AND RUNS just fine....
>
> Where am I going wrong?
>
> Brian Ackermann
>
>
Hi Brian,

I see from your compile log that you've built the debug version of version
2.5.0. When you created your Dev-C++ project, where did you get the compiler
defines and linker flags? Is it from the wx-config file?

When you do "make -f makefile.unx", the wx-config file is used in the build
process.
Since this works, you might want to take a look at wx-config file to see the
compiler defines and linker flags and compare them with your Dev-C++ project
settings.

Best Regards,
Yeoh
--
P.S. I'm off on a trip, so will be away from the pc for a week or so. :-)