Re: [Contiki-developers] STM32W

[Konstantin K. <kkl...@gm...>]

You're right, I've just recalled that I had to solder a wire on MB950.

Please look at the board, there are two soldering pads marked "CAV2", they
are between STM32F and SWD port.
One of the pad is going to STM32F pin, the other one is going to GND. It
was hard to solder both wires to that small pads, so I've just soldered the
one going to pin, and used ground on the USB connector body.
Comparing the schematics of MB951 and MB950 you can see that CAV2 is
actually a "button". You have to short it (or connect to other source of
ground onboard) and plug in.

The firmware is the same.

2012/4/20 Giacomo Tanganelli <gia...@gm...>

> Thanks so much for your reply. My problem with the firmware was little
> different. After the start of the bootloader the utility said "Device
> firmware is more recent than expected. Are you using an old version of
> this software?". Anyway I used a win32 computer with hyperterminal
> (Ymodem) and I was able to flash the CompositeForSTM32W.bin on the
> MB951 and now in ubuntu it works perfect. My last (hope last) question
> is how to have the same bootloader on the MB950. I try to press all
> buttons but i can't access to the bootloader.
>
> Giacomo Tanganelli
>
> --
Best regards,
Konstantin Klubnichkin