TELE and TEPT Settings Locations

COmputational fluid dyNamics STRUctured grid CreaTor for 2D airfoils

Brought to you by: montagdp

TELE and TEPT Settings Locations

Forum: General Discussion

Created: 2018-10-30

Updated: 2019-04-11

KHE - 2018-10-30

Hello,
On page 18 of the manual there appear to be additional commands that I cannot find in the program commands that would be beneficial to my application.
"This can be done using the TELE and TEPT settings in Construct2D."

I need to use TELE and TEPT Settings as suggested to reduce my skew angles. I did not see these commands listed in the manual's command listings as well and would very much like to know how to access them.
Thank you for the help, and great program.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Marcelino - 2019-04-11

Hi, The same doubt here. How is possible to use TELE, TEPT or BUNC?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.