mesh conversion .p3d to openfoam format and boundary conditions

COmputational fluid dyNamics STRUctured grid CreaTor for 2D airfoils

Brought to you by: montagdp

mesh conversion .p3d to openfoam format and boundary conditions

Forum: General Discussion

Creator: REJISH

Created: 2014-04-02

Updated: 2014-04-11

REJISH - 2014-04-02

Hi I used this meshing tool for creating mesh but how can I give boundary condtions to my mesh....how can i separate the farfield into two separate domain for giving input and output boundary conditions...

thanks for your help...

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Rajib Roy - 2014-04-09

Hi REJISH,
C mesh: Applying autoPatch should work
O mesh: After AutoPatch, need to break the boundary patch(i did it manually).

Best,
Rajib

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

REJISH - 2014-04-11

thanks for your comment...I am looking for the procedure to break the boundary patch could you please tell me how to break the boundary patch.......???
i am a new user to openFoam i did it till autopatch but i dnt know how to proceed further to break boundary patch in O mesh...

Last edit: REJISH 2014-04-12

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.