#8 hub4com: Framing error stops ports

[the-moog]

with the following setup
com0com cnca0 cncb0
com0com cbca1 cncb1

hub4com --octs=off --baud=38400 --route=all:all \\.\COM1 \\.\CNCB0 \\.\CNCB1

Physical device on COM1 (autobaud)

Software under test (pyserial app) on cnca0

Hyperterminal on cnca1, used to monitor output only.

If the physical device on COM1 causes a framing error, hub4com reports:
Error COM1: FRAME, total RXOVER=0 OVERRUN=0 RXPARITY=0 FRAME=1

After that no port will respond until hub4com is restarted.

WindowsXP pro

[Vyacheslav Frolov]

Logged In: YES
user_id=918965
Originator: NO

I've tested hub4com. It works correctly after framing errors for me.
So probably there is other reason of the problem.
For example it can be because your physical device begin working for some reason
on other (not 38400) baudrate.

[SourceForge Robot]

Logged In: YES
user_id=1312539
Originator: NO

This Tracker item was closed automatically by the system. It was
previously set to a Pending status, and the original submitter
did not respond within 14 days (the time period specified by
the administrator of this Tracker).