Hi all,
I'm trying to restore an image on a bios-handled raid0 (stripe) but it seems that clonezilla doesn't recongnize the partitions at all... here are my steps:
I created the volume from scratch in the raid controller bios
booted in clonezilla
checked the raid with "dmraid -r" for its presence
created the necessary partitions under fdisk
rescanned the raid volume with "dmraid -r" so the system could see the newly created partitions.
Now I can see the volume and all the partitions either under /dev/mapper/isw_blahblah and /dev/dm-0, but when I get to the step to select where I'd like to restore the image I cannot see any of them.
Any suggestions?
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all,
I'm trying to restore an image on a bios-handled raid0 (stripe) but it seems that clonezilla doesn't recongnize the partitions at all... here are my steps:
Now I can see the volume and all the partitions either under /dev/mapper/isw_blahblah and /dev/dm-0, but when I get to the step to select where I'd like to restore the image I cannot see any of them.
Any suggestions?
Thanks
Hello... anyone?
As mentioned here:
http://clonezilla.org/
Software RAID is not supported... You have to use partclone to manually image or clone the partitions.
Steven.