From: Haoqiang Z. <hz...@cs...> - 2004-07-20 14:49:33
|
The previous scheduler patch wasn't fully tested on SMP machines. I am now working on the issue you reported. I will send out another patch once I get it solved. Guillaume Thouvenin wrote: > Selon Haoqiang Zheng <hz...@cs...>: > > > >-----Original Message----- > > >This is the patch for CKRM CPU scheduler based on core e15. It's > > >stable (I think) for uniprocessor systems. It hasn't been tested on a > > >SMP system so I can't say anything about that. > > I tested your patch on SMP system as I am very interested by > statistics that can be gathered for a class about CPU usage. > Compilation was fine except that CKRM CPU Scheduler and CKRM CPU > Monitor must be selected in the config as reported in previous mail > (it doesn't work as a module). A problem occured when booting the > system. It blocked after ACPI started. I copy boot message at the end > of this email. The kernel works fine if the patch is not applied (just > with e15). > > If it can help I can perform some other tests on the SMP system. > > Best, > Guillaume > > > ---------------[ CUT HERE ]------------------------------------------- > Filesystem type is ext2fs, partition type 0x83 > kernel /vmlinuz-2.6.7-e15+cpu root=/dev/sdb3 console=ttyS0 > [Linux-bzImage, setup=0x1400, size=0x1ac1b6] > > Linux version 2.6.7e15+cpu (guill@account) (gcc version 3.2.2 20030222 > (Red Hat Linux 3.2 > 2-5)) #6 SMP Mon Jul 19 13:38:46 CEST 2004 > BIOS-provided physical RAM map: > BIOS-e820: 0000000000000000 - 000000000009f400 (usable) > BIOS-e820: 000000000009f400 - 00000000000a0000 (reserved) > BIOS-e820: 00000000000e8000 - 0000000000100000 (reserved) > BIOS-e820: 0000000000100000 - 000000007fff0000 (usable) > BIOS-e820: 000000007fff0000 - 000000007ffff000 (ACPI data) > BIOS-e820: 000000007ffff000 - 0000000080000000 (ACPI NVS) > BIOS-e820: 00000000fec00000 - 00000000fed00000 (reserved) > BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved) > BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) > 1151MB HIGHMEM available. > 896MB LOWMEM available. > found SMP MP-table at 000ff780 > On node 0 totalpages: 524272 > DMA zone: 4096 pages, LIFO batch:1 > Normal zone: 225280 pages, LIFO batch:16 > HighMem zone: 294896 pages, LIFO batch:16 > DMI 2.3 present. > ACPI: RSDP (v000 NEC ) @ 0x000ff9b0 > ACPI: RSDT (v001 NEC EXP5800 0x00000001 MSFT 0x01000000) @ 0x7fff0000 > ACPI: FADT (v001 NEC EXP5800 0x00000001 MSFT 0x01000000) @ 0x7fff0030 > ACPI: MADT (v001 NEC EXP5800 0x00000001 MSFT 0x01000000) @ 0x7fff00b0 > ACPI: OEMR (v001 NEC EXP5800 0x00000001 MSFT 0x01000000) @ 0x7fff0140 > ACPI: DSDT (v001 NEC EXP5800 0x00000100 INTL 0x20020918) @ 0x00000000 > ACPI: LAPIC (acpi_id[0x00] lapic_id[0x00] enabled) > Processor #0 15:2 APIC version 20 > ACPI: LAPIC (acpi_id[0x01] lapic_id[0x06] enabled) > Processor #6 15:2 APIC version 20 > ACPI: LAPIC (acpi_id[0x02] lapic_id[0x00] disabled) > ACPI: LAPIC (acpi_id[0x03] lapic_id[0x00] disabled) > ACPI: LAPIC_NMI (acpi_id[0x00] high level lint[0x1]) > ACPI: LAPIC_NMI (acpi_id[0x01] high level lint[0x1]) > ACPI: IOAPIC (id[0x08] address[0xfec00000] global_irq_base[0x0]) > IOAPIC[0]: Assigned apic_id 8 > IOAPIC[0]: apic_id 8, version 32, address 0xfec00000, GSI 0-23 > ACPI: IOAPIC (id[0x09] address[0xfec81000] global_irq_base[0x18]) > IOAPIC[1]: Assigned apic_id 9 > IOAPIC[1]: apic_id 9, version 32, address 0xfec81000, GSI 24-47 > ACPI: IOAPIC (id[0x0a] address[0xfec81400] global_irq_base[0x30]) > IOAPIC[2]: Assigned apic_id 10 > IOAPIC[2]: apic_id 10, version 32, address 0xfec81400, GSI 48-71 > ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl) > ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 high level) > Enabling APIC mode: Flat. Using 3 I/O APICs > Using ACPI (MADT) for SMP configuration information > Built 1 zonelists > Kernel command line: root=/dev/sdb3 console=ttyS0 > Initializing CPU#0 > PID hash table entries: 4096 (order 12: 32768 bytes) > CKRM Initialization > ...... Initializing ClassType<taskclass> ........ > ...... Initializing ClassType<socket_class> ........ > CKRM Initialization done > Detected 2791.374 MHz processor. > Using tsc for high-res timesource > Console: colour VGA+ 80x25 > Memory: 2074312k/2097088k available (2475k kernel code, 21644k > reserved, 1003k data, 276k > init, 1179584k highmem) > Checking if this processor honours the WP bit even in supervisor > mode... Ok. > Calibrating delay loop... 5505.02 BogoMIPS > Dentry cache hash table entries: 262144 (order: 8, 1048576 bytes) > Inode-cache hash table entries: 131072 (order: 7, 524288 bytes) > Mount-cache hash table entries: 512 (order: 0, 4096 bytes) > CPU: Trace cache: 12K uops, L1 D cache: 8K > CPU: L2 cache: 512K > CPU: Physical Processor ID: 0 > Intel machine check architecture supported. > Intel machine check reporting enabled on CPU#0. > CPU0: Intel P4/Xeon Extended MCE MSRs (12) available > Enabling fast FPU save and restore... done. > Enabling unmasked SIMD FPU exception support... done. > Checking 'hlt' instruction... OK. > CPU0: Intel(R) Xeon(TM) CPU 2.80GHz stepping 09 > per-CPU timeslice cutoff: 1462.54 usecs. > task migration cache decay timeout: 2 msecs. > enabled ExtINT on CPU#0 > ESR value before enabling vector: 00000000 > ESR value after enabling vector: 00000000 > Booting processor 1/6 eip 3000 > Initializing CPU#1 > masked ExtINT on CPU#1 > ESR value before enabling vector: 00000000 > ESR value after enabling vector: 00000000 > Calibrating delay loop... 5570.56 BogoMIPS > CPU: Trace cache: 12K uops, L1 D cache: 8K > CPU: L2 cache: 512K > CPU: Physical Processor ID: 3 > Intel machine check architecture supported. > Intel machine check reporting enabled on CPU#1. > CPU1: Intel P4/Xeon Extended MCE MSRs (12) available > CPU1: Intel(R) Xeon(TM) CPU 2.80GHz stepping 09 > Total of 2 processors activated (11075.58 BogoMIPS). > WARNING: 1 siblings found for CPU0, should be 2 > WARNING: 1 siblings found for CPU1, should be 2 > ENABLING IO-APIC IRQs > ..TIMER: vector=0x31 pin1=2 pin2=-1 > Using local APIC timer interrupts. > calibrating APIC timer ... > ..... CPU clock speed is 2790.0601 MHz. > ..... host bus clock speed is 132.0885 MHz. > checking TSC synchronization across 2 CPUs: passed. > Brought up 2 CPUs > NET: Registered protocol family 16 > EISA bus registered > PCI: PCI BIOS revision 2.10 entry at 0xfdb55, last bus=4 > PCI: Using configuration type 1 > mtrr: v2.0 (20020519) > ACPI: Subsystem revision 20040326 > Unable to handle kernel NULL pointer dereference > > > > ------------------------------------------------------- > This SF.Net email is sponsored by BEA Weblogic Workshop > FREE Java Enterprise J2EE developer tools! > Get your free copy of BEA WebLogic Workshop 8.1 today. > http://ads.osdn.com/?ad_id=4721&alloc_id=10040&op=click > _______________________________________________ > ckrm-tech mailing list > https://lists.sourceforge.net/lists/listinfo/ckrm-tech |