generic-mmc-raw not working with LG CED-8120B

Brought to you by: andreasm, evenflow, llanero, poolshark

generic-mmc-raw not working with LG CED-8120B

Forum: Help

Creator: Sriram

Created: 2001-10-30

Updated: 2001-11-16

Sriram - 2001-10-30

Dear all

I have an LG CED-8120B which supports raw writing as I could use it comfartably with CloneCD. But when I try to use the same with generic-mmc-raw driver the application is returning error the first of which is a CHECK CONDITION. have anyone successfully used it to do raw writing

Thanks and rgds

Sriram

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Massimo Malatesta - 2001-11-16
  
  I tested my yamaha 8424s with full sucessfull on win98 and subchannel writing (raw writing) and under linux works fine but with generic-mmc. If I try generic-mmc-raw , the procedure starts, on the display I see ....writing 96 byte subchannel data , writing 3Mb of 24...(subchannel data + 700 Mb di data) and six or seven second after the scsi bus hung-up and reset and cdrdao show me the register status .
  I have read the debug messages , and I saw a strange error ; the generic-mmc-raw driver , can't find a FAT partition????
  
  I think that this drivers have been done for reading raw devices but not to write them.
  
  Massimo
  
  P.S. Is possible to ask to the driver proprietary to review it?
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.