BRL-CAD / Patches / #215 Adding pull to BRL-CAD

#215 Adding pull to BRL-CAD

Milestone: Untested

Status: open

Owner: nobody

Labels: None

Priority: 5

Updated: 2013-09-13

Created: 2013-07-24

Creator: Nyah Check

Private: No

This patch adds the pull command into brlcad. This is to show the current working version of command. patch should apply cleanly; but still developing command. make sure you apply with the brlcad root directory

1 Attachments

new_pull.patch

Discussion

Nyah Check - 2013-07-29

here is the modified patch with the 'f_joint' error removed. patch applies cleanly

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Nyah Check - 2013-07-30

or this

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Nyah Check - 2013-08-23

stubbing an empty pull routine into BRL-CAD

pull.patch

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Nyah Check - 2013-08-27

stubbing the pull_comb() routine which pulls matrix transformations from a combination moving up the CSG tree.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Nyah Check - 2013-09-13

stubbing the complete pull routine supporting both combinations and pulling translations from leaves.

pull_patch.patch

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Adding pull to BRL-CAD

Open Source Solid Modeling CAD

Group

Searches

Help

#215 Adding pull to BRL-CAD

Discussion