I am frusted because I am not able to contect my V500W Speedport which is conected via Ethernet to the standard Sphairon from my provider Alice.
I had read in the Howto`s section how it should work, but I am not shure if I tryed it on the correct way... I insert the below shown taskes in Custom script control, bit without any result!?
Dear all,
I am frusted because I am not able to contect my V500W Speedport which is conected via Ethernet to the standard Sphairon from my provider Alice.
I had read in the Howto`s section how it should work, but I am not shure if I tryed it on the correct way... I insert the below shown taskes in Custom script control, bit without any result!?
# pppd -c 1.32.1 -i eth0 -u USERNAME -p PASSWORT -f 0 -P 1 -d &
pppoe device is init.
---------
# echo "1" > /proc/var/fyi/wan/ppp_1_32_1/wanup
---------
ioctl(PPPIOCSNPMODE, 33, 0): Inappropriate ioctl for device (25)
ioctl(PPPIOCSNPMODE, 33, 3): Inappropriate ioctl for device (25)
read /dev/ppp: No such device or address
Starting link
PPP: PPP1_32_1 Start to connect ...
Sending PADI
Sent packet: Ether addr: ff:ff:ff:ff:ff:ff
(PPPOE Discovery)
[...]