Please help me with my robotic's project, I'm trying to make robot using GPIO pins on W500V, but I have few problems.
I need to use GPIO as input and it will be very good to activate all 20+ GPIO lines not only reset button + 7 LEDS.
I already did this before on different platform (ADM5120) and OpenWrt / DD-Wrt.
So just show me the way to move.
Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
GPIO and LED map stored in file: \dev_tree\bs_extra\ledtool\src\board_api.h
I can set any of GPIO state , but I have prob when i try to get state from GPIO.
I'm trying to init GPIO's like reset button in Bitswitcher but with no success.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
GPIO and LED map stored in file: \dev_tree\bs_extra\ledtool\src\board_api.h
I can set any of GPIO state , but I have prob when i try to get state from GPIO.
I'm trying to init GPIO's like reset button in Bitswitcher but with no success.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
GPIO and LED map stored in file: \dev_tree\bs_extra\ledtool\src\board_api.h
I can set any of GPIO state , but I have prob when i try to get state from GPIO.
I'm trying to init GPIO's like reset button in Bitswitcher but with no success.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Please help me with my robotic's project, I'm trying to make robot using GPIO pins on W500V, but I have few problems.
I need to use GPIO as input and it will be very good to activate all 20+ GPIO lines not only reset button + 7 LEDS.
I already did this before on different platform (ADM5120) and OpenWrt / DD-Wrt.
So just show me the way to move.
Thank you.
Hi there,
Did you ever figure out how to do the GPIO and LED?
Actually I want to know more regarding the LED control, can you shred some light on this??
Many thanks!
usage (Led State); example: ledtool 1 4
LED:
" 0 Power green
" 1 Power red
" 2 ADSL
" 3 Online
" 4 PSTN
" 5 Internet
State:
" 0 Off
" 1 On
" 2 Fail (red)
" 3 BlinkOnce
" 4 SlowBlinkContinues
" 5 FastBlinkContinues
" State 2 to 5 is only available for LED 1, 2 and 3.
Thank you very much.
But I am actually trying to use bitswitcher on another box(non w500v), it currently boots fine but the LED is not mapped correctly.
Do you know where I can find the definition of the LED and GPIO pin so that I can change around to test it? Thank you so much in advance.
GPIO and LED map stored in file: \dev_tree\bs_extra\ledtool\src\board_api.h
I can set any of GPIO state , but I have prob when i try to get state from GPIO.
I'm trying to init GPIO's like reset button in Bitswitcher but with no success.
GPIO and LED map stored in file: \dev_tree\bs_extra\ledtool\src\board_api.h
I can set any of GPIO state , but I have prob when i try to get state from GPIO.
I'm trying to init GPIO's like reset button in Bitswitcher but with no success.
GPIO and LED map stored in file: \dev_tree\bs_extra\ledtool\src\board_api.h
I can set any of GPIO state , but I have prob when i try to get state from GPIO.
I'm trying to init GPIO's like reset button in Bitswitcher but with no success.