Re: [Alsa-user] RESEND: Unable to get CS4236+ driver working on IBM Thinkpad 600

[pongo <po...@sy...>]

Thank you, I will try using snd_isapnp=0. In regards to the "snd_"
prefix with the recent version, I'm using the 0.5 stable version--
should I be using the recent, 0.9-development, version to get it
to work properly with linux kernel 2.4 ?

Greg

---------- Original Message ----------------------------------
From: Takashi Iwai <ti...@su...>
Date: Tue, 03 Dec 2002 16:04:32 +0100

>At Tue,  3 Dec 2002 08:53:23 -0600,
>pongo wrote:
>> 
>> This is a resend of a message I sent earlier, before I realized I
>> had to subscribe to the mailing list (which I just did with
>> "confirm 380418).
>> 
>> ---------- Original Message ----------------------------------
>> From: "pongo" <po...@sy...>
>> Reply-To: <po...@sy...>
>> Date: Sun,  1 Dec 2002 16:42:47 -0600
>> 
>> I've been trying to get  the CS4236 sound device on a Thinkpad 600
>> working with its existing Mandrake linux:
>> 
>>  Linux wren.birdview 2.4.8-26mdk #4 Wed Nov 27 17:35:10 EST 2002
>> i686 unknown
>> 
>> I have the kernel source, and recently recompiled it in an effort
>> to try to diagnose what the problem might be, to no avail. I
>> originally thought there was a problem with the isapnp detection
>> (it is built into the kernel, not a module), but now I think the
>> documentation I've been following on the web site might not give
>> the same result for a 2.4+ kernel as it did on the 2.2 kernel
>> (pnpdump never detects anything, for example).
>> 
>> The syslog always shows 
>> Dec  1 15:44:16 wren kernel: snd: isapnp detection failed and
>> probing for CS4236
>> + is not supported
>> Dec  1 15:44:16 wren kernel: snd: CS4236+ soundcard #1 not found
>> at 0x530 or dev
>> ice busy
>> and I'm sure the settings I'm setting in modules.conf or directly
>> giving on the modprobe command line are correct:
>> modprobe snd-card-cs4236 snd_port=0x530 snd_cport=0x538
>> snd_mpu_port=-1 snd_fm_port=0x388 snd_irq=5 snd_dma1=1 snd_dma2=0
>
>pass snd_isapnp=0 in addition.
>
>also, please note that the recent version of alsa driver uses the
>module options without snd_ prefix.
>
>
>Takashi
>