Re: [Aironet] Unable to determine radio type

[Francis S. <fra...@as...>]

David,

Two possible problems:

1. A firmware problem between the Radio Module
(actually this is a LM4800/PC4800) and the
AP4800 firmware.

2. Loose or Damaged Radio Module



------

The AP4800 firmware checks the radio module
firmware during initial boot up.  If the AP4800
finds a conflict it "re-flash" the LM4800 with the
proper Radio Code.

------

Suggestion 1.

Remove the LM4800 and reinstall it again.
Power up AP4800.

Suggestion 2.

Remove the LM4800 and install it on a Notebook
PC with PCMCIA Slot.  PC Card Drivers are available
at the Cisco Web site or WinME/Win2K.

Check the LM4800 if it's working on the Notebook.
If not...attempt to reflash it with the latest PC Card firmware.

If all these fail....most likely it's a damage LM4800.



Francis







At 10:46 PM 12/14/2001 -0800, David Morales wrote:
>I have an AP4800.  This error : "Unable to determine
>radio type"
>
>keeps coming up every 10 seconds or so.  I do not see
>ssid options under configuration-radio.
>
>I also do not seeanything about 802.11 on the menus.
>
>I have updated firmware, everytime it says , NO RADIO
>CODE
>
>How do I re-establish the radio code?
>
>__________________________________________________
>Do You Yahoo!?
>Check out Yahoo! Shopping and Yahoo! Auctions for all of
>your unique holiday gifts! Buy at http://shopping.yahoo.com
>or bid at http://auctions.yahoo.com
>_______________________________________________
>Aironet mailing list  -  Ai...@cs...
>http://csl.cse.ucsc.edu/mailman/listinfo/aironet