Menu
▾
▴
#13 gaiptek crashes on start
Plugged in my Adesso 12x9 tablet
and it basically works out of the box with no config on
Ubuntu 6.06LTE but:
- no pressure sensitivity
- no eraser
- cant reach edge of monitor, not calibrated right
So I downloaded and built gaiptek from trunk and got:
robertj@l3ktr0n:~/cvs/aiptektablet/trunk/gaiptek$ gaiptek
The program 'gaiptek' received an X Window System error.
This probably reflects a bug in the program.
The error was 'BadDevice, invalid or uninitialized
input device'.
(Details: serial 248 error_code 169 request_code 147
minor_code 3)
(Note to programmers: normally, X errors are reported
asynchronously;
that is, you will receive the error a while after
causing it.
To debug your program, run it with the --sync
command line
option to change this behavior. You can then get a
meaningful
backtrace from your debugger if you break on the
gdk_x_error() function.)
robertj@l3ktr0n:~/cvs/aiptektablet/trunk/gaiptek$
----
T: Bus=03 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1
Spd=12 MxCh= 2
B: Alloc=118/900 us (13%), #Int= 1, #Iso= 0
D: Ver= 1.10 Cls=09(hub ) Sub=00 Prot=00 MxPS=64
#Cfgs= 1
P: Vendor=0000 ProdID=0000 Rev= 2.06
S: Manufacturer=Linux 2.6.15-26-686 uhci_hcd
S: Product=UHCI Host Controller
S: SerialNumber=0000:00:1d.3
C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 0mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00
Driver=hub
E: Ad=81(I) Atr=03(Int.) MxPS= 2 Ivl=255ms
Logged In: YES
user_id=1534109
Originator: NO
Got the same problem!
The program 'gaiptek' received an X Window System error.
This probably reflects a bug in the program.
The error was 'BadMatch (invalid parameter attributes)'.
(Details: serial 250 error_code 8 request_code 147 minor_code 23)
(Note to programmers: normally, X errors are reported asynchronously;
that is, you will receive the error a while after causing it.
To debug your program, run it with the --sync command line
option to change this behavior. You can then get a meaningful
backtrace from your debugger if you break on the gdk_x_error() function.)