winamp plugin with an fm801
Brought to you by:
dynamite
From: Darron B. <da...@ke...> - 2005-05-25 11:59:09
|
Hi there. I have been playing around with an FM801 based card and recently installed winamp with adplug on an XP machine. I have set things up but fail to get any sound from the OPL3 device within the FM801. From literature obtained online about the FM801 ( FM801-Linux.doc ) we can see that it has it's OPL registers at offset 0x0068 consequently after installing the porttalk driver I informed the winamp plugin to utilise the addresses found at 0x9068, where 0x9000 was the base address obtained from the windows driver infomation applet for the Fm801 device. I may be just assuming too much expecting this to work so simply, but the winamp plugin did not complain about not finding an OPL3 device, so perhaps I can reasonably assume that this is working as I anticipated. With regard to no sound, however, it is also interesting to note that the FM801 has other registers outside the OPL spec which adjust it's volume and indeed enable the FM synthesizer. These registers are obviously not adjusted by the plugin. Anyway, after this massive preamble I reach a question for the list: I would like to update any code locally for the plugin/core to determine if the other registers mentioned above are indeed stopping noise emanating from the fm801 or not, hence I would like some advice from knowledgable adplug coders as to what source files I need to play with to try and get this to make a sound. Thanks darron PS. There is no means to adjust the FM volume in windows via the sound control applet, plus using the FM synth as the output midi device works in media player. -- // / {:)==={ Darron Broad <da...@ke...> \\ \ |