From: Denis V. <vd...@il...> - 2005-12-11 16:36:12
|
On Saturday 10 December 2005 17:38, Harry Orenstein wrote: > Just wanted to report that I got the Hawking HWP54G working. Details below: > > Driver: 20051202 > Firmware: tiacx111c16 1.2.1.34 > Kernel: 2.6.10-1.770_FC3 > > I got this working with auto rate (I've seen anywhere from 1M to 36M) and > WAP using a restricted mode key and it works automatically on boot up. > > I did have a couple of questions: I order to get the driver to compile I had > to change both "#ifdef CONFIG_PM" in pci.c to "#ifndef CONFIG_PM" since my > kernel has CONFIG_PM and the code within the #ifdef does not want to compile > on my system. There is mention in the comments that "PM code needs to be What was the error? > fixed / debugged / tested". Is it a problem not enabling power management? > Is there any info I can supply that will assist the developers to get this > working? By describing in detail how it does not work. Compile errors, logs of suspend/resume cycle, etc... > Also: when the driver loads it seems to configure USB for the card (usbcore: > registered new driver acx_usb in the log) even though it is PCI. Is this It registers the driver, but finds no usb devices to operate on. > the result of the PCI and USB modules having been combined (the first > version of the driver I tried to run was acx100-0.2.0pre8_plus_fixes_57, > which had separate PCI and USB modules)? Is this normal? Yes, it's ok. Most of driver code is shared between pci and usb. -- vda |