[Acx100-devel] [RATCH/RFC] install irq handler early

[Denis V. <vd...@po...>]

I had problems with IRQ sharing.

acx100_reset_dev() enables interrupts, but irq handler is
not yet installed! Kernel complains "IRQ 11: nobody cared!"
and kills off my innocent ethernet device...

With this patch, I was able to execute:

# modprobe acx_pci firmware_dir=$firmware_dir debug=0xffff
# iwconfig wlan0 essid zeon
# iwconfig wlan0 mode managed
# ip l set dev wlan0 up

without errors. However, card still cannot accociate with
nearby AP....

dmesg snippets attached. One is gzipped to fit 40k mail
size limit for mailing list.

Please note that patch is not meant for inclusion, it's
a bit brute-forced to work. It's 02:45 here...

Comments?
--
vda