[Acx100-devel] [ acx100-Support Requests-906592 ] module load O.k. but system stop

[SourceForge.net <no...@so...>]

Support Requests item #906592, was opened at 2004-02-28 21:10
Message generated for change (Tracker Item Submitted) made by Item Submitter
You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=543746&aid=906592&group_id=75380

Category: None
Group: None
Status: Open
Priority: 5
Submitted By: zimmermo (zimmermo)
Assigned to: Nobody/Anonymous (nobody)
Summary: module load O.k. but system stop

Initial Comment:
Hello,
i have SUSE 9.0 with Kernel 2.4.21-athlon.

I have got a SMC 2435 - acx100 card.

Everything works on my Computer with SuSE 7.3. But
since I have installed the new SuSE 9.0 the same
installation failed.

I tried everything with pre5 and pre7 and with aktuell
firmware 2.9.8 and correct firmware 2.8.3 for pre5.

The Failure:
I put in the card, the module loades correct.
The card start's scanning and sometimes it can find my
Access Point correct, but after a few seconds
everything stopps - this mens nothing work - no mouse -
no other console - nothing!!!

When I pull out the card - everything runs on.

I can't find where the Failure ist.

Here ist a short log at the end of the initialisation,
short bevor everything stopps:

kernel: acx100_set_status: Setting iStatus = 0 (STARTED)
kernel: Updating WEP key settings
kernel: Updating transmit power: 20 dBm
kernel: changing radio power level to 20 dBm (0x3f)
kernel: Updating antenna value: 0x8F
kernel: Updating energy detect threshold: 112
kernel: Updating Channel Clear Assessment value: 0x0D
kernel: Updating: enable Tx
kernel: Updating: enable Rx
kernel: Updating short retry limit: 5, long retry limit: 3
kernel: Updating xmt MSDU lifetime: 2048
kernel: Updating regulatory domain: 0x30
kernel: Updating channel: 1
kernel: acx100_set_status: Setting iStatus = 1 (SCANNING)
kernel: get_mask 0x00000000, set_mask 0x00000000  -
after update 
kernel: start queue on startup.

That's all - and no nothing happens.

For Info: my PWR Light ist on and for a few seconds the
DATA / Transmit Light goes on.

Please help me! Thanks.

p.s. there is a file with debug=0xffff  for developers!

----------------------------------------------------------------------

You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=543746&aid=906592&group_id=75380