Search Results for "switch device"

Espressif ESP32 Based Smarthome screen for MQTT. Control your MQTT/HomeKit Smart Home Devices from an ESP32-powered screen. Homepoint is a screen-based interface for MQTT & HomeKit-connected Smarthome devices that runs on the ESP32 Chipset. See partially switched-on scenes with multiple devices at a glance. Support for temperature, humidity, air quality sensors & Tasmota energy readings. Remote Configuration: Configure and reboot HomePoint through a web interface. No need to reflash....

...The goal of this project is to use Arduino hardware with C language programming to manipulate the guitar signal by various effects of phaser, flanger, reverb, digital delay and echo, and tremelo. Also, the signals of two microphones, two guitars, and one mp3 device will be inputted into and passed through two 3-band programmable equalizers. All of the processed signals will pass through and be amplified by a clean master volume controlled power amp. The digital effects will be toggled by means of a floor panel controlled by digital foot switch controller communication with the Arduino hardware via a digital cable. ...

This project was originally designed to provide an open-source replacement for PPJoy. The product, at this point, consists of virtual joystick devices that is seen by the system as a standard joystick but its position-data is written to it by a feeder application. An existing feeder application that takes advantage of this product is SmartPropoPlus. If you are an application writer you can very easily write an application that controls a joystick (e.g. mouse-to-joystick,...

PUB! is a Programmable USB Button on which you can program with a sequence of keystrokes. When you press the button those keystrokes are "replayed" over a USB connection. The button is programmed using an innovative and slightly quirky interface that does not require any custom software to be installed on your computer. All you need is a text editor like Notepad or gedit.

VMPS (VLAN Management Policy Server) is a way of assigning switch ports to specific VLANs based on MAC address of connecting device. OpenVMPS is a GPL implementation of VMPS.

The 'NES Open Switch' is a network protocol stack. It contains the protocol implementation required to run a networking device in a computer network. NES Open Switch supports various networking media as: Ethernet, SDH/Sonet, OTN and WDM. The supporting protocols for different media are being developed as individual modules in the stack. For example for Ethernet media support protocol modules like STP, CFM and LACP are present in the stack.