Search Results for "usdt flash program"

NodeMCU is an open source Lua-based firmware for the ESP8266 WiFi SOC from Espressif and uses an on-module flash-based SPIFFS file system. NodeMCU is implemented in C and is layered on the Espressif NON-OS SDK. The firmware was initially developed as a companion project to the popular ESP8266-based NodeMCU development modules, but the project is now community-supported, and the firmware can now be run on any ESP module.

stlink is an open source toolset to program and debug STM32 devices and boards manufactured by STMicroelectronics. It supports several so-called STLINK programmer boards (and clones thereof) which use a microcontroller chip to translate commands from USB to JTAG/SWD. There are four generations available on the market which are all supported by this toolset.

FlashProg is USB base flash memory programmer which is specifically design to read and program 3.3V SPI flash memory devices.

prog89S52 is a utility for Linux on the PC, allowing programming of Atmel's AT89S52 microcontroller via the parallel printer port. Atmel's 89S are programmable via an SPI port and therefore require absolutely no additional components in order to program them in-system. This program requires a standard "Centronics" type PC parallel port (a bidirectional, EPP or ECP port is not required). A 5-way cable is required to connect the microcontroller to the port; wiring information is given in the included manual page. Remember that a clock source is required in order to program the device, and that EA must be tied to Vcc when programming the internal flash memory. ...

Program GameBoy Advance cartridges with the Flash Advance Linker using your Amiga!