Search Results for "cable"

...All of the processed signals will pass through and be amplified by a clean master volume controlled power amp. The digital effects will be toggled by means of a floor panel controlled by digital foot switch controller communication with the Arduino hardware via a digital cable. Also, the preamp signal can be alternatively connected to a separate power amp.

THIS PROJECT MIGRATED TO https://gitlab.com/mwetoolkit/mwetoolkit3/ The Multiword Expressions toolkit aids in the automatic identification and extraction of multiword units in running text. These include idioms (kick the bucket), noun compounds (cable car), phrasal verbs (take off, give up), etc. Even though it focuses on multiword expresisons, the framework is quite complete and can also be useful in any corpus-based study in computational linguistics. The mwetoolkit can be applied to virtually any text collection, language, and MWE type. It is a command-line tool written mostly in Python. ...

...Atmel's 89S are programmable via an SPI port and therefore require absolutely no additional components in order to program them in-system. This program requires a standard "Centronics" type PC parallel port (a bidirectional, EPP or ECP port is not required). A 5-way cable is required to connect the microcontroller to the port; wiring information is given in the included manual page. Remember that a clock source is required in order to program the device, and that EA must be tied to Vcc when programming the internal flash memory. Note that since prog89S52 uses ioperm() and friends to access the underlying port hardware, you may need to run it as root. ...

BASIC interpreter for the 16bit PIC microcontroller 24FJ64GA002. The interpreter runs on the chip only, no compiler/tokenizer is needed. Communication with PC is done by USB-to-serial converter cable.