Search Results for "byte"

Engineering, testing and debugging of serial communication. Supports RS-232/422/423/485 as well as TCP/IP Client/Server/AutoSocket, UDP/IP Client/Server/PairSocket and USB Ser/HID. Optimized for simple command sets of e.g. embedded systems.

A modern, stand alone browser-based serial terminal for UART communication with microcontrollers, embedded devices, and IoT hardware. No installation required - just open in your browser and connect to your serial device. Just unpack the zip file into local folder and open index.html in Chrome/Edge/Opera. Works on Windows/Linux/MaOS

PROJECT MOVED TO: https://github.com/damogranlabs/serial-tool See releases page: https://github.com/damogranlabs/serial-tool/releases Serial Tool is a utility for developing serial communications, custom protocols or device testing. You can set up bytes to send accordingly to your protocol and save configuration to a file – which can be used another time. You can send multiple byte arrays, you can send sequence of different byte arrays and put delay between them. You can read data in HEX or ASCII. You can even write a note to yourself like: “CH1: toggle LED 1”.

...The 'Vertical' tab displays the comm link conversation in a vertically-scrolling half-duplex mode. Each 'side' of the conversation is detected by the user-configured 'start msg' and 'end msg' byte sequence. The 'Horizontal' tab shows bytes, one at a time, as they are received on each side of the link so the relative timing relationships can be monitored. Printable ASCII chars are shown. Non-printable are shown with a '0x' prefix. The two sides of this link referred to as 'Port 1' and 'Port 2'. Each side must communicate at the same baud rate. ...