Search Results for "serial-studio"

An USB programmer for various devices, including PIC, dsPIC, AVR microcontrollers, and various kinds of serial eeproms

What is it? It's a Bootloader for Microchip, Atmel, NXP, TI and 8051 devices. A Bootloader is a firmware running in the microcontroler device which allows the user to send it's own firmware without the need of a programmer. This Bootloader consists of: - firmwares for many devices (this firmware need to be send to the device's flash memory with a programmer, only once) - a PC software which communicates with the bootloader firmware in the device and send the user's program in its...

A simple to use serial communication software for communicating with other serial, MCU and Arduino. The SoftIB Serial Communicator communicates with other Serial devices that use a simple asynchronous communication using only the RX and TX signals without any control signals. The application was developed based on the communication with microcontrollers, but it can be used in all other cases.

...This is a version based on the PIC16F877A microcontroller running with a 20MHz clock. The maximum sampling rate is 1 MHz with a 5 Mhz equivalent sampling mode. Currently, the computer interface supports USB, serial, and parallel ports. Good luck on the construction and I hope you enjoy your oscilloscope. I am happy to answer any questions or provide technical support for this design.

Project implementing simulator of virtual CPU with additional tools. Application written in C# 4, .Net Framework 4.0 , Visual Studio 2010 Features: - IDE- like environment with MDI interface - Customizable (plug- ins) architecture: instruction sets, directives, registers, additional MDI windows - Own assembler using Intel syntax producing binary programs - Simulation of i386- like CPU operating on multi- level cache and RAM - Simulation of debugger and memory view - Features of simple OS: scheduling, multi- tasking by context switching, memory management Currently available version considered "initial". ...

The cc3 project provides software for embedded vision systems. Currently, the software runs on the CMUcam3 hardware platform, which is a NXP LPC2106-based board with an onboard CMOS camera and FIFO, MMC interface, serial UARTs, and servo controller.

uGNU/RTOS (literally "micro G'Noo RTOS") is an Open Source serial Real Time OS for microcontrollers (PIC, ATMEL).

Keep It Simple Bus is a PC+MCU based Robotics Framework that utilizes serial port to interface to multiple DC/Servo/Stepper motors through PIC12F683 ising binary protocol. Main goal is to do it as cheap as possible with minimal number of components, fast

MuCTools is a group of command line utilities connect with Philips'P89C668 (8051 type) and other Philips microcontroller bootloaders, completing the 8051 development chain with free software for linux. muctools0.9 works with limited features. See README

PicOload is a programmer and a bootloader that allow to program a PIC 16f87X / 16f87XA using a RS232 serial line whithout leaving the chip from his support and without disturbing the rest of the device

Computer Vision Software designed for AttyTheWalker, a made from scratch hexapod robot. Entirely developed in C language for GNU/Linux platforms it's the best way to move the robot using a personal computer with RS-232 serial communication.